|
|
KRYPTANE Urethane
Products
We formulate
unique proprietary Kryptane urethane materials specifically
tailored to meet the demands of your particular wear application,
whether it be sliding or impact abrasion, sticking or corrosion.
Our lightweight Kryptane material eases installation and reduces
noise. Kryptane's corrosion resistance and hydrolytic stability is
an added benefit when performing in wet conditions and chemical
solutions. Sheet materials are available in standard 4' x 10' size
from 1/8" to 1" thick. Large sizes and custom geometric
shapes are available upon request. Maximum sheet sizes of
5-1/2" wide x 60' long can be obtained. Sheets are available
in plain, fabric backed, expanded metal backed and weldable
configurations. Options for installation include adhesive, nail
shot, welding and a variety of common fasteners. Argonics also has
available Kryptane urethane capped bolts used in conjunction with
our universal counterbore tool. Further installation information
is available upon request. |
| Typical Applications
Mill
trommel, trunnion and chute liners
Distributor and launder liners
Chute, bin, and hopper liners
Impact and abrasion resistant plates
Screens, check plates, and hold downs
Filtration sectors, ferrules, and external tubes
Hydrocyclone and dusty cyclone liners
Slurry pump liners
Flotation cell and mixer liners
Salt, sand, and chemical spreaders
Roll, pulley, and sheave wheel lining
Down hold plugs and discharge sleeves
Pipe, fitting, and valve liners
Vibration pads, seals, and gaskets
Chain and cable guides
Blasting curtains and screens
Truckbed liners, wheelchocks, crossover pads
Snowplow blades, shoes, and deflectors
|
KRYPTANE POLYURETHANES
Kryptane
80A Red
Used for fine particle, shallow angle, sliding abrasion. Excellent
for grain handling, sand blast curtains, hydrocyclone parts, and
pump replacement parts.
Kryptane
90A Red
Used for fine particle abrasion associated with sticking and
hang-up problems. This material has the lowest coefficient of
friction of any of the typical Kryptane products. Typical
applications are classifier shoes and pipe elbows.
Kryptane
83A Green
Used for coarser particle, higher angle of impingement wear
problems with 2" minus materials. This formulation has
excellent cut and tear resistance. Common uses are belt scrapers,
chute liners, and mixer liners.
Kryptane 93A Black
Used for the toughest applications handling up to 5" minus
materials. This material has the highest tensile and tear
strengths of the standard Kryptane products. Typical applications
include drage line bucket liners, impact bars, grizzlies, and
layered belt scrapers.
The above list references our standard
materials. We aggressively pursue development of application
specific formulations. Please consult your Argonics Representative
for further information on our other performance-based
polyurethane materials.
|
